The Redline N7 Milsim Gen2 is a patented HPA cylinder
replacement system.
This is an updated version of our legendary N7 Milsim, the very
first fully mechanical closed system HPA motor. Like the N7
Milsim GEN1 no battery or FCU is needed!
The N7 Milsim Gen2 comes with our new and improved trigger
valve.
The upgraded trip valve features a short push for a clean trip.
There is no cross air leakage when the trigger is pulled slowly,
so no matter how you squeeze the trigger, you get some clean
trigger action.
The most noticeable change from the N7 GEN1 is the elimination
of the external air line to the nozzle.
We have also updated the internal components and reduced the
size of the inner tube slightly.
Functionally however, it is identical to the original N7 Milsim GEN1.
This means you get the same performance and easy setup that
the N7 GEN1 engines were known for.
Due to its true closed bolt design and balanced air nozzle return,
the N7 Milsim Gen2 performs very well compared to an HPA open
bolt system.
The result is faster firing speed, tighter groupings, and greater
distance accuracy.
Like the N7 Gen1, the N7 Milsim Gen2 uses a mechanically
sealed dump chamber.
Rather than relying on a solenoid to control the volume of air
used to propel the BBs, the N7 Gen2 fills an internal air chamber
to the pressure set by the user's external power regulator.
When fired, this air chamber is mechanically sealed from the feed
and the contents of the chamber are released into the barrel to
propel the bbs.
This feature contributes to the excellent consistency between
shots of the N7 Milsim Gen2.
The N7 Gen2 is easy to install. Since there is no time delay to set,
all you need to do is adjust the output pressure of your power
regulators to match the required joules and you're good to go.
You will always have the right amount of air needed for each shot,
regardless of ball weight, barrel length, or any other factor.
Heavily reinforced AEG gearboxes may require modifications.
Gearboxes with heavy reinforcing in the geardrive area
behind the trigger, may require the removal of some of the
reinforcement.
Main features of the N7 Milsim Gen-2:
True closed bolt, fully mechanical and pneumatic operation of the
HPA system.
True weatherproof design without battery or FCU.
Very simple setup, little or no adjustment required.
Easy adjustment thanks to its true closed bolt design.
Fixed zone discharge chamber design.
Less “joule creep” than conventional HPA systems.
100% designed and made in the USA
This HPA system is a spare part, it does not constitute a
guarantee of results, it is delivered without an installation manual
and is reserved for experienced and equipped preparers.
By purchasing this system, you declare that you are technically
able to install it and make the necessary modifications to the
replica for its proper functioning.
On products fitted with a trigger board, any breakage of the plate
and trigger selector contact buttons is not guaranteed by the
manufacturer.
Regarding the plate selector, we recommend that you do not
force the button or push it in the opposite direction during
installation.
Regarding the trigger button, it is strongly recommended that
the trigger stroke be mechanically locked once the switch is
activated to avoid excessive pressure with the finger on the button.
Per info e/o acquisto veloce senza account:
info@softair-italia.it |
Abbigliamento Tattico-Tecnico -> 
Archi-Balestre & Accessori 
HPA High Pressure Airsoft ->
